Multisteno: Difference between revisions
(add infobox) |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Incomplete}} | |||
The [https://nollelectronics.com/products/multisteno-case-and-cables-included Multisteno] is a hobbyist steno writer made by [https://nollelectronics.com/ Nolltronics]. | The [https://nollelectronics.com/products/multisteno-case-and-cables-included Multisteno] is a hobbyist steno writer made by [https://nollelectronics.com/ Nolltronics]. | ||
| Line 6: | Line 7: | ||
By default, the Multisteno uses the Gemini PR protocol. | By default, the Multisteno uses the Gemini PR protocol. | ||
See | {{See also|Setting up a hobbyist writer with Plover}} | ||
== Layers == | == Layers == | ||
| Line 20: | Line 21: | ||
=== Firmware === | === Firmware === | ||
The Multisteno is powered by QMK. | The Multisteno is powered by QMK. | ||
[[Category:Hardware]] | |||
Revision as of 17:06, 23 May 2025
This page is incomplete. If you know about this subject, please contribute to the wiki by adding more information.
The Multisteno is a hobbyist steno writer made by Nolltronics.
 |
|
| Manufacturer | Nolltronics |
|---|---|
| Connector | USB-C |
| Key switch | Kailh Choc |
| Stock key weight | 20 grams |
| Spring swap | Yes: 15 grams, 12 grams |
| Alternative key caps | MBK |
| Javelin | No |
Use with Plover
By default, the Multisteno uses the Gemini PR protocol.
- See also: Setting up a hobbyist writer with Plover
Layers
Mods
MBK key caps
The default key caps can be replaced with MBK key caps.
Spring swapping
The default springs bottom out at 25 grams of force, but can be swapped with SPRiT springs that bottom out at 20 grams.
Firmware
The Multisteno is powered by QMK.